Powering The Cdx-36150 Recorder - Canon CDX-36150 Manual

Preparations
NOTES
• Be careful not to obstruct in any way the recorder's air vents.
• To use the camera's DC IN 12V terminal when the recorder is attached
4
to the camera, remove the cover next to the CDX-36150 Recorder's
DC IN terminal.

Powering the CDX-36150 Recorder

Connect the power supply to the CDX-36150 Recorder before turning on the camera. While the CDX-36150
Recorder is docked with the camera, power is supplied to the camera from the power source connected to the
CDX-36150 Recorder. You can also connect a power source directly to the camera's DC IN 12V terminal.
1 Press the camera's Q button to turn off the camera.
2 Connect the power supply (DC IN or battery) to the recorder.
• Refer to the CDX-36150 Recorder's Getting Started Guide.
3 Press the camera's
• The LED on the top of the CDX-36150 Recorder will illuminate in different colors to indicate the recorder's
status. Refer to the following table.
CDX-36150 Recorder's LED status
LED
Blue Record standby mode.
While recording, or the power level of the power source connected
Red
to the CDX-36150 Recorder is low.
Green During playback.
The camera is turned off or the main recording format is set to an
Off option other than [RAW (
[ProRes (
You can press the button inside the ring to change the LED's
brightness between 3 levels or to turn it off completely. Even when you
turn it off, the LED will illuminate in red if a low power warning is
triggered.
Q
button to turn on the camera.
Recorder status
Capture Drive)] or
Capture Drive)].
Air vents
Cover
LED