Replacing The Drive Belts; Cleaning; Cleaning The Machine - Toro CM-658H-S Operator's Manual

Replacing the Drive Belts

Service Interval: Every 100 hours
Note: The machine has 2 drive belts. Remember to buy 2
belts for replacement.
1. Complete steps 1 through 3 in Adjusting the Drive-belt
Tension (page 35).
2. Slide the engine to the right to decrease the belt tension.
3. Remove the drive belts from the pulleys.
4. Install the new drive belts on the pulleys.
5. Slide the engine to the left until the belts have the right
amount of tension; refer to Checking the Drive-belt
Tension (page 35).
6. Torque the 4 mounting nuts and bolts to 24 N-m (18
ft-lb) each (Figure 54).
7. Install the divider plate; refer to Installing the Divider
Plate (page 28).

Cleaning

Cleaning the Machine

Regular cleaning and washing with mild detergent and water
will increase the life span of the machine. Clean the machine
after each use before the dirt hardens.
Remove dirt and grime from the external parts of the entire
machine, especially the engine. Clean dirt and concrete
materials from the outside of the engine.
Ensure that the fuel cap and the oil-fill cap/dipstick are
secure to avoid getting water in the engine.
Use care when using a high-pressure sprayer because it can
damage safety decals, instruction signs, and the engine.
36