Sony 158N5100BT Operating Instructions Manual page 28

The phone sound quality is poor.
-+
Phone sound quality depends on reception
conditions of cellular phone.
- Move your car to a place where you can
enhance the cellular phone's signal if the
reception is poor.
The volume of the connected audio device is low
(high).
-+
Volume level will differ depending on the audio
device.
-Adjust the volume of the connected audio
device or this unit.
The sound skips during playback of a
BLUETOOTH audio device.
-+
Reduce the distance between the unit and the
BLUETOOTH audio device.
-+
If the BLUETOOTH audio device is stored in a case
which interrupts the signal, remove the audio
device from the case during use.
-+
Several BLUETOOTH devices or other devices
which emit radio waves are in use nearby.
-Turn off the other devices.
- Increase the distance from the other devices.
-+
The playback sound stops momentarily when the
connection between this unit and the cellular
phone is being made. This is not a malfunction.
The connected BLUETOOTH audio device cannot
be controlled.
-+
Check that the connected BLUETOOTH audio
device supports AVRCP.
Some functions do not work.
-+
Check if the connecting device supports the
functions in question.
A call is answered unintentionally.
-+
The connecting phone is set to answer a call
automatically.
Pairing failed due to a timeout.
-+
Depending on the connecting device, the time
limit for pairing may be short.
-Try completing the pairing within the time.
BLUETOOTH function cannot operate.
-+
Turn off the unit by pressing OFF for more than 2
seconds, then turn the unit on again.
No sound is output from the car speakers during
handsfree call.
-+
If the sound is output from the cellular phone, set
the cellular phone to output the sound from the
car speakers.
28GB
Siri Eyes Free is not activated.
-+
Perform the handsfree registration for an iPhone
that supports Siri Eyes Free.
-+
Set the Siri function on the iPhone to on.
-+
Cancel the BLUETOOTH connection with the
iPhone and the unit, and reconnect.
Application name is mismatched with the actual
application in "SongPal".
-+
Launch the application again from the "SongPal"
application.
While running the "Song Pal" application via
BLUETOOTH, the display automatically switches
to [BT AUDIO].
-+
The "SongPal" application or BLUETOOTH
function has failed.
-+
Run the application again.
The "SongPal" application is automatically
disconnected when the display switches to [IPD].
-+
The "SongPal" application on iPhone/iPod does
not support iPod playback.
-Change the source of the unit to other than
[IPD], then establish the "SongPal" connection
(page 16}.
Pandora® connection is not possible.
-+
Shut down the Pandora® application on the
mobile device, and then launch it again.
CD ERROR: The disc cannot be played. The disc will
be ejected automatically.
-+
Clean or insert the disc correctly, or make sure the
disc is not blank or defective.
CD NO MUSIC: There is no playable file. The disc
will be ejected automatically.
-+
Insert a disc containing playable files (page 24}.
CD PUSH EJT: The disc could not be ejected
properly.
-+
Press
~
(eject).
HUB NO SUPRT: USB hubs are not supported.
IPD STOP: iPod playback has finished.
-+
Operate your iPod/iPhone to start playback.
OVERLOAD: The USB device is overloaded.
-+
Disconnect the USB device, then press SRC to
select another source.
-+
The USB device has a fault, or an unsupported
device is connected.