IDENTIFICATION AND ORDERING
MODEL AND SERIAL NUMBERS
The cutting unit has two identification numbers: a model
number and a serial number. The two numbers are
stamped into a plate that is located on left side plate of
the cutting unit (Fig. 1). In any correspondence
concerning the cutting unit, supply the model and serial
numbers to assure that correct information and
replacement parts are obtained.
To order replacement parts from an authorized TORO
Distributor, supply the following information:
1.
Model and serial numbers of the machine.
2.
Part number, description and quantity of parts
desired.
Note: Do not order by reference number if a parts
catalog is being used; use the part number.
figure 1
1. Model & serical number plate
3