Siemens SCALANCE W760 Series Operating Instructions Manual page 22

Description of the device
3.5 LED display
LED
P1
R1
Note
Primary user (radar) on all enabled channels (only when DFS is enabled)
If the device detects competing radar signals on all enabled channels of the WLAN interface,
the F LED is lit and R1 flash. No data traffic is then possible for the next 30 minutes. After
this time, the device runs the scan again and checks whether a primary user still exists. If no
primary user is detected, data traffic is possible again.
The wait time of 30 minutes is necessary due to legal requirements and cannot be shortened
even by restarting the device.
22
Color Meaning
Flashing red The bootloader waits in this state for a new firmware file that you can
download by TFTP.
Interval:
500 ms
on / 500 ms off
Red A competing radar signal was found on all enabled channels.
Simultaneous
R1 yellow
flashing
Flashing yellow The port LEDs flash for detection of device location.
The "LED flash" function is
Either with SINEC PNI
•
Or via the WBM page "Discovery and Set via DCP"
•
Operating Instructions, 07/2020, C79000-G8976-C322-12
SCALANCE W760/W720