Toro ProPass 200 Operator's Manual page 15

Figure 18
1. Rubber seal
2. Steel gasket
3. Ensure that the steel gasket and rubber seal are seated
in the channel in the remote and set the back cover
in place (Figure 18).
4. Secure the cover with 6 screws
them to 1.5 to 1.7 N-m (13 to 15 in-lb).
5. Install the handheld remote into the magnetic remote
bracket, slide the halves together to secure the remote,
and tighten the bolt in the magnet
Figure 19
1. Handheld remote
2. Magnetic remote bracket
3. Handheld remote
4. 4 AA batteries
(Figure 18) and torque
(Figure 19).
3. Bolt in the magnet
8
Mounting the Wireless Remote
Model 44751 Only
Parts needed for this procedure:
1 Controller mount assembly
1 Wireless remote assembly
Procedure
Insert the controller mount assembly into a cup holder or
similar opening on the tow vehicle and use to store wireless
remote. Also, the wireless remote magnet will stick to any
metal component.
Workman Heavy Duty Vehicle Shown
1. Remote
15
Figure 20
2. Controller mount assembly