Gaining Access To Parts 2Ff; Stand Assembly - Philips PM 5125 Manual

2R
Gaining access to parts
A. REMOVING THE TOP PLATE
The top plate may be removed after loosening the fastener at the rear [ ]
of the instrument.
To refit the top plate, place the groove of the fastener in the horizontal
position and push the cover home.
B. REMOVING THE SIDE PLATES
The side plates may be taken off after removing the screw on each side of
the instrument.
C. REMOVING THE BOTTOM PLATE [ j
The bottom plate may be removed after loosening the appropriate screws
at the rear of the cabinet.
~~
D. REMOVING THE STRIP WITH TILTING SUPPORT
This strip may be removed by pushing the two nylon slides "A" in the ~
1
direction indicated in Fig. 11.
~g.
J
E. REMOVING THE PLUGIN PRINTED WIRING BOARDS ~ M
In order to pull out the plug-in printed wiring board of the power
supply, the two fixing screws "P" (Fig. 17A) should first be removed
leaving the brackets "Q" (Fig. 17A) fixed to the board. [ ,
J
c
1
~~ J
Fig. 11. Stand assembly