Panasonic KX-UDS124 Manual page 5

Slow green flashing
Moderate green flashing
Red ON
Slow red flshing
Moderate red flashing
Amber ON
Slow amber flashing
Moderate amber flashing
Slow flashing = 60 x per minute
Moderate flashing = 120 x per minute
You can connect up to 255 mobile devices (Panasonic KX-UDT1x1) to the base station KX-UDS124.
The maximum number of parallel calls is 4 per base station.
Maintain the distances listed below between equipment in order to prevent noise,
interference or thedisconnection of a conversation. (The distance may vary depending on
the environment.)
More then 2 meter
machine, etc.
More then 5 meter
2.2.3. Installation DECT Base KX-UDS124 Slave
To install a Panasonic KX-UDS124 in slave mode, you do not have to change the settings in the
administration portal. You need an access to the master KX-UDS124 over the web interface.
Follow these steps:
No. Description
1. One master KX-UDS124 must be already installed, as described in section 2.2.1.
2. You need to know the IP address of the master, you can get it either:
with your connected handset, Menu>Setting Handset>Other Option>MasterCSAddress
or with an IP network scanner (e.g. netscan)
3. Open your web browser, e.g. Firefox, ...
4. enter the IP address.
5. A new window appears, here you have to enter a userID and a password. This information is
provided by your system partner. It is NOT the standard Panasonic userID and password.
6. Now you connect your slave UDS124 to your network. Please wait untill the LED is flashing
RED.
Talk (active calls) / S-PS data transfe
Busy, all voice channels are occupied
Fault
Out of Service/Starting up
Starting up
Stand-by, unsatble synchronisation
Talk (unstable synchronisation)
Busy (unstable synchronisation)
SIP-CS and office equipment such as a computer, telex, fax
SIP-CS and other radio device
Picture
5