Maintenance And Cleaning - Bosch PMD 7 Original Instructions Manual

OBJ_BUCH-1913-002.book Page 24 Monday, September 23, 2013 12:33 PM
24 | English
Cause Corrective Measure
Measurement results inaccurate/implausible
Interfering metal Remove all interfering metal objects (e.g. watch,
objects in the area of bracelet, ring, etc.) from the sensor area. Do not
the sensor hold the device close to the sensor.
Auto calibration not Perform a manual calibration.
successful
Continuous flashing green/yellow/red,
even when no metal or "live" cable is in the vicinity.
Measuring tool is Send the measuring tool in for service.
defective
* Therefore, please also observe other information sources (e.g. construction plans)
before drilling, sawing or routing into walls, ceilings or floors.

Maintenance and Cleaning

Wipe away debris or contamination with a dry, soft cloth. Do not use
cleaning agents or solvents.
In order not to affect the measuring function, decals/stickers or name
plates, especially metal ones, may not be attached in the sensor area 6 on
the front or back side of the measuring tool.
After-sales Service and Application Service
Our after-sales service responds to your questions concerning mainte-
nance and repair of your product as well as spare parts. Exploded views
and information on spare parts can also be found under:
www.bosch-pt.com
Bosch's application service team will gladly answer questions concerning
our products and their accessories.
In all correspondence and spare parts orders, please always include the
10-digit article number given on the type plate of the measuring tool.
2 609 140 996 | (23.9.13) Bosch Power Tools