Mounting The Cradle - Motorola Symbol STB20 Series Quick Reference Manual

8
Reconnect the power supply, if required.
4.
If necessary, scan the appropriate host bar code (for non-autodetected
5.
interfaces). Refer to the User Guide.
CAUTION
If the scanner does not recognize the host, disconnect the power
supply, then reconnect after connecting the host cable.

Mounting the Cradle

Horizontal Mount
The cradle is packaged with the horizontal mount desk cup installed (see
1.
5). If it was replaced with the wall cup, remove the wall cup
Features on page
and reattach the desk cup.
Use a Phillips screwdriver to turn the converter knob to the correct position for
2.
a desktop/horizontal mount (see
Attach the appropriate cables.
3.
Place the cradle on the desk to and insert the scanner.
4.
Vertical Mount
To mount the cradle on a vertical surface:
Use a Phillips screwdriver to turn the converter knob to the correct position for
1.
a vertical (wall) mount (see
engage the depressions at the base of the scanner's handle.
Use a Phillips screwdriver to remove the screws on the back of the cradle as
2.
pictured and follow the steps below to install the wall cup.
Use fingers to squeeze cup release
snaps while pulling out desk cup.
1 2
Attach the interface and power cables to the appropriate ports (see
3.
Connections).
Press the cables into the cable grooves.
4.
Position the cradle on the mounting surface, or use the template included in
5.
DRAFT
this guide.
Symbol STB20XX Cradles
Features on page 5).
5). The front latches protract to
Features on page
Desk Cup
4
3
Wall Cup
5