Setting Wireless Lan - Canon imageClass MF4890dw Settings Manual

Setting Wireless LAN

Push Button Mode
1
Press [ ] (Menu) .
2
Select <Network Settings>, and then press [OK] .
3
Select <Wireless LAN Settings>, and then press
[OK] .
4
Press [OK] .
5
Select <WPS Push Button Mode>, and then
press [OK]
Wireless LAN Settings
WPS Push Button Mode
WPS PIN Code Mode
SSID Settings
Wireless LAN Informa
. . .
6
Select <Yes>, and then press [OK] .
7
You should press the WPS button within 2
minutes after you select <Yes> in step 6 . Press
and hold* the button until the lamp lights or blinks .
* The time that you should hold the button may vary depending
on the router you are using .
Wait approximately 2 minutes after the connection.
IP address is set during this period of time .
When an error message appears:
Press [OK] to close the screen, check whether or not
the network key is correct, and then retry the settings .If
the access point cannot be detected even after retrying,
see the following .
e-Manual "Onscreen Messages"
When checking the network connection:
You can check if the machine is properly connected to the
network using a computer that connected to a network .
"Checking That the Wireless LAN Setting is Completed"
(P .6)
To set IP address manually:
e-Manual "Setting the IPv4 Address"
Setting the Access Point Manually
If you do not know SSID (access point name) and network
key that you are using, check a label attached on the
wireless LAN router or use "Canon MF/LBP Wireless Setup
Assistant" ("Checking SSID or Network Key for a Wireless
LAN Router/Access Point" (P .7) to know your SSID and
network key .) Write down the SSID and network key below,
for reference .
SSID
It is sometimes written as name of network, or name of
access point . If there are multiple SSIDs, please write
down all .
Network Key
It is sometimes written as PIN, WEP key, WPA/WPA2
passphrase, PSK or preshared key .
1
Press [ ] (Menu) .
2
Select <Network Settings>, and then press [OK] .
3
Select <Wireless LAN Settings>, and then press
[OK] .
4
Press [OK] .
5
Select <SSID Settings>, and then press [OK] .
6
Select <Select Access Point>, and then press
[OK] .
SSID Settings
Select Access Point
Manual Settings
7
Select the access point that you wrote down, and
then press [OK] .
If multiple matched SSIDs are displayed, select the ID
that is listed first (the one with the strongest signal) .
Proceed to the next page
5
En