Light Kit
Greensmaster 3050 and 3100
Part No. 105-3848
Preparing the Traction Unit
Caution
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect
the wire(s) from the spark plug(s) before you do
any maintenance. Set the wire(s) aside so that it
does not accidentally contact the spark plug(s).
1. Disconnect the negative (–) battery cable from the
battery.
2. Remove the left cover plate (Fig. 1).
1
3
2
Figure 1
1. Left cover plate
2. Lockout bracket
3. Remove and discard the rear bolt securing the lockout
bracket to the frame (Fig. 1). Save the washer and
locknut.
2004—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
3. Rear bolt
Printed in the USA
All Rights Reserved
Form No. 3327-362 Rev A
Installation Instructions
4. Remove the cover shield from the side of the control
panel (Fig. 2).
2
Figure 2
1. Cover shield
Installing the Light Switch
(Greensmaster 3050 only)
1. Remove the plastic plug from the control panel
(Fig. 3).
1
Figure 3
1. Plastic plug
Register your product at www.Toro.com
1
2. Control panel
Original Instructions (EN)