Philips Hadco ZoneScape 1-A Documentation page 17

11. Wait 20 seconds for the unit to reboot. Now if you connect the
ZoneScape unit via Ethernet cable to the target WiFi router you should be
able to access ZoneScape via a WiFi connection to the router.
If you have entered incorrect settings, you will need to reset to factory defaults the
ZoneScape module by holding the "reset" button with a screwdriver for at least 10
seconds. After factory reset , please follow the steps from 1 - 11 and make sure that
you set ZoneScape in the same network as the WiFi 802.11 router. Below is a
example showing a configuration of ZoneScape in the 192.168.1.* network and a
wired connection to a TP-LINK wireless router.
Net Mode: Default
By default the ZoneScape WEB configuration interface can be accessed by visiting
http://192.168.16.254 and entering the default credentials - username: admin and
password: admin
If ZoneScape is not set in "Default" it should be set to "Default" from the Net Mode
dropdown menu.
Then the user needs to click on the "Apply Button" and wait for around 20 seconds
for the module to save settings and reboot.
ZoneScape 1-A module documentation
.
Proposal Page 17 of 28