Point; 1: Point Programming For 5815Xl Module - Honeywell Farenhyt Series Installation And Operation Manual
Addressable fire alarm control system emergency communication system
Hide thumbs
Also See for Farenhyt Series:
- Manual (176 pages) ,
- Installation and maintenance instructions (4 pages) ,
- Installation instruction (2 pages)
Table of Contents
Advertisement
5.
Enter the Template number, then press ENTER
6.
Press ENTER on the template name to edit the name.
You can use words to display a descriptive name for a group.
NOTE: See Appendix B for editing names.
7.
Right arrow to the OPG and select YES or NO to select which output groups to include in the template.
9.5 Point
You may need to change characteristics of individual input points (detectors and switches) even after using JumpStart. This section
explains how to change options for: type of input point; latching/non-latching status (switches); and name and zone/group assignment of
a point.
9.5.1 Point Programming For 5815XL Module
To program for points on an 5815XL module, follow these steps:
1.
Enter the installer code. The panel will automatically go to the main menu.
2.
Select 7 for Panel Programming.
3.
Press 4 to enter point menu.
4.
Press the up or down arrow key to select the desired module. Refer to Section 8.5 Quick Reference Table for available choices.
Then press ENTER.
5.
Enter the number of the point you wish to edit, then press ENTER.
6.
Select the type of device by pressing the up or down arrow key. Refer to Table 9.4 under the column heading "Type Selection" for a
list of choices.
115
IFP-300 / IFP-300ECS Manual P/N LS10145-001SK-E:B 12/18/2017
Advertisement
Table of Contents
Troubleshooting
