Sony WF-1000XM3 Service Manual page 6

WF-1000XM3
4. Attach the left and right headset to your ears. Then the audio
playback from the NFC compatible device, and check that the
sound is output from the left and right headset.
Note 3: Sound is not output just by attaching a headset on one side. Be sure
to attach the left and right headset.
R
R
tap once
5. Touch the N-Mark part of the charging case with N-Mark of the
NFC compatible device again to disconnect the connection, and
complete the operation check.
Note 4: Before returning the product to the customer, refer to "INITIALIZ-
ING METHOD" on page 7 and delete the Bluetooth device pairing
information.
6
L
or
RESETTING METHOD
If this unit does not operate properly, perform the reset.
Note 1: Even if this work is performed, device pairing information is not
deleted. Also, other settings are retained.
Resetting procedure:
1. Attach the left and right headset to the charging case.
L R
2. Touch and hold the touch sensor control panel on the left side
headset (WF-1000XM3L), and the indicator changes from red
lighting to red fl ashing, then check the indicator is turn off and
the then release your fi nger.
Note 2: It takes about 20 seconds to touch and release the touch sensor con-
trol panel.
Touch sensor
control panel
L R
Red lighting: Touch and hold
L R
Red flashing: Touch and hold
3. Touch and hold the touch sensor control panel on the right side
headset (WF-1000XM3R), and the indicator changes from red
lighting to red fl ashing, then check the indicator is turn off and
the then release your fi nger.
Note 3: It takes about 20 seconds to touch and release the touch sensor con-
trol panel.
Touch sensor
control panel
L R
Red lighting: Touch and hold
L R
Red flashing: Touch and hold
4. The reset is complete.
Sony CONFIDENTIAL
For Authorized Servicer
L R
Turn off: Release your finger
L R
Turn off: Release your finger
SYS SET