Installing Dry Contact Input Devices; Dlli8I8O And Dpmi940-Dali; Ddmidc8 - Philips dynalite Installation Manual

Installing dry contact input devices

DLLI8I8O and DPMI940-DALI

1. Install as close to the switching source as possible.
2. DLLI8I80 has an RS-485 interface and can be connected to eight open/close contacts and eight indicator
LEDs.
3. DPMI940-DALI has a DALI interface and can be connected to four open/close contacts
(must be used with a Dynalite DALI Multimaster controller).
Refer to installation instructions for cable length, safety insulation, requirements, and limitations.
A

DDMIDC8

1. Robust device recommended for locations with EMF noise, long cable runs up to 50 m (165 ft), where
additional optical isolation for dry contacts is required or for analog control integration.
2. Can be installed without a DIN rail by extending DIN rail clips to expose mounting screw holes.
3. If used, connect voltage-free contacts or 0-24V AC/DC inputs to any of the eight opto-isolated inputs.
Remove the cover and ensure that the internal jumpers for each input are set to the appropriate 0-24V or
voltage-free setting, according to the input type.
4. Setting the internal jumper to the volt-free position increases the current consumption of the device from
15mA to 40mA. This must be considered when selecting DyNet data cable and supply capacity.
5. If used, connect 0-5 V or 0-10 V inputs to the analog ports. Ensure the input is a maximum of 10 VDC.
Faders can be directly connected to the analog inputs by using the adjacent +5V terminal as a supply.
Suggested fader value is 10K ohm. Analog input circuits must be SELV/Class 2 (UL).
6. Only draw a maximum of 25mA from the +5V terminal.
14 th November 2019
DLLI8I8O
DDMIDC8
DPMI940-DALI
Dynalite Hardware
.......................................
Installation Guide
.......................................
Page 13
.......................................
www.philips.com/dynalite