Philips Avalon CTS M2720A Quick Start Manual page 2

M2720A Avalon CTS
Cordless Fetal Transducer System
Quick Start Guide
110 - 240 V AC
Remove transducer
The transducers are pre-warmed up to body temperature in the base station. Please advise your
patient before applying the transducer.
Changing from US to DECG monitoring
1 Dock the US transducer.
2 Take out the ECG transducer when the lamp
slot is green.
3 Connect the DECG adapter cable M1362B and the fetal scalp
electrode to the ECG transducer.
4 Start DECG monitoring.
Two active transducers transmitting FHR to the same base station cause error message E9. To clear, dock one transducer.
After Use: Clean transducers. Then dock in appropriate base station slot.
Power on
"Ready" lamp goes out: "RF
Link" lamp comes on
Changing from DECG to US monitoring
1 Disconnect the DECG adapter cable M1362B and the fetal scalp
electrode from the ECG transducer.
for that 2 Dock the ECG transducer.
3 Take out the US transducer when the lamp
green.
4 Start ultrasound monitoring.
Wait for "ready" lamp
Fetal monitor
Apply transducer (use gel for
US)
for that slot is