Solution control panel, and used solely for remote control of external devices connected to the two on-board relays. The BOSCH 2 channel radio interface is a 304 MHz receiver, with the ability to store up to 120 radio remote control codes. The receiver “learns” the transmitters code during the teaching procedure as outlined below and stores the code in its internal memory.
Page 3
Arm/Disarm In AWAY Mode Arm/Disarm In STAY Mode Panic Alarm Via Transmitter Operate Relay 1 With Momentary Operation Operate Relay 2 With Momentary Operation Operate Relay 1 With Toggle Operation Operate Relay 2 With Toggle Operation Bosch Security Systems Pty Limited ISSUE100.DOC...
Page 4
Panel Codes Default (Panel Codes Only) Remove power, hold down SW4 and power up Table 1: Defaulting Procedures Wiring To connect the 2 channel receiver to an BOSCH Solution control panel, wire the receiver in parallel with the system codepad(s). 2 Channel Receiver Solution Panel...
Page 5
UHF frequencies. Ensure the antenna has plenty of free space around it. Close proximity to any metal will reduce their effectiveness and thus range. Picture 1: 2 Channel Radio Receiver And Interface Board Bosch Security Systems Pty Limited ISSUE100.DOC...