Chapter 6 - Start-Up; Basic Startup - Toshiba 18 - 1250 A Instruction Manual

TE Series

Chapter 6 - Start-up

Digital Solid State Soft Starters 18 – 1250A
6.1

Basic Startup

Your new TE Series Soft Starter is factory preset for a wide variety of
applications and often can be used with minimal adjustment.
6.1.1 Three Step Process
1. Connect L1, L2, and L3 to power lines and
T1, T2, and T3 to motor.
2. Connect control wires and control power.
3. Program motor FLA (F001).
6.1.2 Start-up Parameters and Factory Defaults
Try the initial presets first and then adjust or enable the more
advanced features to meet your specific starting needs.
Function
Fn #
Name
Motor Nameplate
F001
FLA.
Motor Nameplate
F002
Service Factor
Overload Class
F003
During Start
Overload Class
F004
During Run
F005 Overload Reset
F010 Ramp Profile
F011 Initial Torque
F013 Ramp Time
F014 Current Limit
F015 –
Ramp 2 settings
F018
Software protection
F019 –
and control
F052
features
Internal hardware
F053
protection features
F054 – Timer and counter
F059 value readouts
F060 Aux Relay #1
F061 Aux Relay #2
F062 Aux Relay #3
F063 Aux Relay Delay
F065 –
Communications
F068
F070 Parameter Lock
F071 Reset Function
F073 – System settings
F080 and time clock
F085 –
Fault History
F093
Table 6.1.2: Factory Presets
62
Factory
Description / Factory Setting
Setting
FLA must be programmed for
0
starter to function.
Change only if necessary AND
1.0 SF
motor is rated over 1.0SF
Class 10 NEMA / UL Class 10
Class 10 NEMA / UL Class 10
0 (Manual) 0 = Manual
Ramp 1 and Ramp 2 =
1
Voltage Ramp with Current Limit
60 60% Initial Voltage
10 10 Second Ramp (Ramp 1)
350 350% of programmed FLA
Inactive unless Ramp 2 Input is
---
closed
--- Inactive unless selected
127 All active
--- Read only
1 Run / Stop
2 At-Speed / Stop
16 Any Trip
0 No Delay
Not Used unless without optional
----
Comm Adaptor
0 User password disabled
0 Use to reset to default values
--- User choice to adjust clock
--- Read only