Advertisement
1. Remove the drain plug
from the drain port.
2. Remove the fill plug from
the fill port.
6.
Rock the cutting unit back and forth to ensure
complete drainage. When the oil is completely
drained, place the cutting unit on a level surface.
7.
Install the drain plug.
8.
Use a syringe (Part No. 137-0872) to fill the
drive box with 80-90W oil (approximately 90 cc).
1. Syringe with 80-90W oil
9.
Install the fill plug and tighten the air-vent plug.
10.
Torque all plugs to 3.62 to 4.75 N∙m (32 to 42
in-lb).
Figure 25
3. Loosen the air-vent plug.
Figure 26
2. Fill port
g240875
Right side groomer box shown
1. Air-vent plug
2. Fill plug
Removing the Groomer
Drive Box
Note:
Retain all removed parts for later installation
unless otherwise stated.
Important:
If you have any issues removing the
groomer drive box, refer to your traction unit
Service Manual or contact your authorized Toro
distributor.
1.
Remove the cap from the groomer.
2.
Remove the clamp bolts connecting the groomer
to the drive box
3.
Remove the adjuster pin and cotter pin
connecting the groomer drive box to the adjuster
arms
(Figure
g240898
17
Figure 27
3. Drain plug
(Figure
15).
28).
g241100
Advertisement
