Appendix 4 System Mode; A4.1 Operation Panel - Toshiba B-492L Owner's Manual

APPENDIX 4 SYSTEM MODE

APPENDIX 4 SYSTEM MODE
IMPORTANT!
If System Mode is needed for
any other purposes, please
contact a TOSHIBA TEC
authorized service
representative before
performing any operation in
System Mode.

A4.1 Operation Panel

NOTE:
Use the [RESTART] key to
resume printing after a pause
condition, or after clearing an
error.
Appendix 4 describes usage of the keys on the Operation Panel in System
Mode.
For end users, System Mode should be used for the following five
purposes:
To reset the printer. (Reset mode)
To check and print the system status, the Maintenance Counter, and
to check the Print Head Elements.
To make fine adjustment to the media handling.
To perform a test print for checking print quality.
To print the raw data being received by the printer (Dump mode).
The figure below shows the Operation Panel and key functions.
LCD Message Display
POWER LED
(Green)
[RESTART] key
[FEED] key
The LCD Message Display shows messages to indicate the printer's
current status. Up to 16 characters can be displayed on this line.
There are three LEDs on the Operation Panel.
LED
POWER
The printer is turned on.
ON LINE The printer is ready to print.
ERROR Any error occurs on the printer.
In System Mode, the [FEED], [RESTART] and [PAUSE] keys
function as described below.
Used to navigate the parameter mode or to fine adjust
FEED
the parameters in the negative direction (- Down).
Used to release the printer from Pause condition, to
navigate the parameter mode, or to fine adjust the
parameters in the positive direction (+ Up).
RESTART
By pressing and holding the [RESTART] key in Pause
condition for more than 3 sec., the printer enters the
system mode.
Used to stop printing operation temporarily, to select
the parameter mode, or used as an enter key.
By pressing and holding the [PAUSE] key in Pause
PAUSE
condition for more than 3 sec., the printer enters the
threshold setting mode.
A4- 1
POWER ON LINE ERROR
FEED RESTART PAUSE
Illuminates when...
EO1-33032
A4.1 Operation Panel
ERROR LED (Red)
ON LINE LED (Green)
[PAUSE] key