Panel Unit - Brother ADS-1000W Service Manual

8.11 Panel unit

(1) Remove the taptite cup S M3x5 screw to disconnect the second side CIS FG harness from
the machine.
(2) Press the lock lever R, open the panel unit and upper document chute. Bend the machine
inward to remove the two bosses on the upper document chute, and remove the panel unit
and upper document chute from the machine. Release the two FG harnesses and two flat
cables from the securing fixtures.
(3) Remove the two taptite bind B M3x8 screws from the upper document chute.
Boss
HARNESS ROUTING: Refer to
on the left side at the
Note:
• Be careful not to lose the core.
Taptite bind B M3x8
Lock lever R
Panel unit and
upper document chute
Fig.3-18
"4. Main PCB ASSY top
bottom".
3-23
Taptite cup S M3x5
Second side CIS FG harness
Boss
side", "6. Frame L"
Core
Taptite bind B M3x8
and "7. Flat cable
Confidential