Open the drawer and the glass lid.
c
b
a
Place the vacuum adapter over the
vacuum pump air intake valve .
Attach the connector to the
container lid. Make sure that the
closure of the lid is turned to
"seal" (closed).
Switch the drawer on with the
sensor.
The and sensors will light up.
Touch the sensor.
The and sensors go out. The
and sensors will light up.
Touch the sensor repeatedly until
the segment for the required vacuum
level lights up.
Touch the sensor.
The vacuuming process will start.
Leave the glass lid open for the entire
duration of the vacuuming process.
If an excessive number of bubbles
forms, you can cancel the vacuuming
process by pressing the sensor
(see "Operation - Cancelling the
vacuuming process").
After the vacuuming process
A signal sounds.
Detach the connector from the
container lid. Make sure that the
closure of the lid is still turned to
"seal" (closed).
Remove the vacuum adapter from the
vacuum pump air intake valve.
Before starting a new vacuuming
process, check that the vacuum
adapter, the tube and the vacuum
chamber are clean and dry.
Remove any soiling or liquid residues
if necessary.
Operation
27