Hitachi AW130 Handling Instructions Manual page 40

English
Water is not being
discharged.
The water pressure
won't rise.
The trigger stopper is locked.
The faucet it turned off .
The nozzle is blocked.
The strainer is blocked.
The power plug is not plugged
into the power socket.
The switch is set at "OFF".
The water volume or pressure
from the faucet is too low.
The nozzle is blocked.
The electrical voltage is too low. Check to make sure that the thickness
Water is leaking.
Remedy the problem in accordance
with the details listed in "Trigger
Stopper" on page 36.
Open the faucet fully.
Clean the end of the nozzle with the
nozzle cleaner pin supplied.
Wash the strainer, which is
incorporated into the water feed inlet,
in accordance with the details listed in
"Inspecting the Strainer" on page 38.
Plug the power cord into the power
socket.
Switch the washer on.
○ Open the faucet fully.
○ Unravel any twists in the water
hose and high-pressure hose.
○ Check to make sure that the inner
diameter of the water hose is
correct.
○ Check to make sure that the water
hose is not wound onto the reel.
Clean the end of the nozzle with the
nozzle cleaner pin supplied.
and length of the extension cord is
appropriate.
Check the hose connections.
40