Faq Information And Latest Updates - Philips TSU9600/93 Starter Manual

TSU9600 Starter's Guide
The Control Panel shows one of the following icons
No connection
• The Wireless Access Point is powered down.
• The Control Panel is out of range of the Wireless Access point.
• There is an encryption problem.
No identification
• There is no IP address received.
• An IP conflict is detected.
The WiFi icon is not shown on the screen of the Control Panel
You cannot see the WiFi icon:
• When the extenders and the Control Panel are configured in Stand-Alone.
• When you disabled the system item WiFi Level in the ProntoEdit Professional.
The Control Panel behaves erratically
Normally, resetting the Control Panel is not necessary. However, if the touch screen freezes or if you
notice unusual behavior, you need to perform a reset to get it running again.
You reset the Control Panel by switching the Power switch to 0, waiting a few seconds and
switching the Power switch back to 1.

FAQ Information and Latest Updates

You can find more information on www.pronto.philips.com.
Navigate to the Support section for more FAQ Information.
Navigate to the Downloads section for the following updates:
• TSU9600 Control Panel Firmware;
Download this on the Control Panel when it does not start up or when the screen stays black
after resetting.
• RFX9400 and RFX9600 Extender Firmware;
• ProntoEdit Professional Software.
Note Installing the latest update of the ProntoEdit Professional software will overwrite all files and
delete the personal images you added to the gallery. Make sure to update the gallery when
requested in the wizard to copy your personal images to the new gallery.
11