Introduction; Systems Requirements; Establishing The Connection - Bosch AUTODOME IP starlight 5000i IR User Manual

6 en | Introduction
1

Introduction

1.1

Systems requirements

–
–
–
–
–
–
–
–
–
1.2

Establishing the connection

The unit must have a valid IP address to operate on your network and a compatible subnet
mask.
By default, DHCP is pre-set at the factory to On plus Link-Local so a DHCP server assigns an
IP address or, if no DHCP server is available, a link-local address (auto-IP) is assigned within
the range 169.254.1.0 to 169.254.254.255.
You can use IP Helper or Configuration Manager to find the IP address. Download the software
from http://downloadstore.boschsecurity.com.
1.
2.
3.
If a RADIUS server is used for network access control (802.1x authentication), you must
configure the device before the device can communicate with the network.
To configure the device, connect it directly to a computer using a network cable and then set
the service-level password.
Note:
If you cannot connect, the unit may have reached its maximum number of connections.
Depending on the device and network configuration, each unit can have up to 50 web browser
connections, or up to 100 connections via Bosch Video Client or Bosch Video Management
System.
2019.11 | 1.2 |
Computer with Intel Skylake processor or better
Intel HD530 graphic card with performance that matches or is better than the resolution
of the camera
Windows 7 (or newer) operating system
Network access
Web browser:
– Internet Explorer version 11 (or newer)
Mozilla Firefox
Application software, for example, Video Security Client, Bosch Video Client, BVMS, or
Project Assistant app.
DirectX 11
MPEG-ActiveX 6.33 (or newer) [required to see, in your browser, live images from the
camera]
Configuration Manager 6.20 (or newer)
Start the Web browser.
Enter the IP address of the unit as the URL.
During initial installation, confirm any security questions that appear.
User Manual
AUTODOME IP starlight 5000i IR
Bosch Security Systems