Advertisement
3
Push the slide selector to the ON position.
4
Close the battery compartment.
When battery is installed
•
To switch on the Presenter, push the USB receiver into the
Presenter and then remove the USB receiver from it.
•
To switch off the Presenter, push the USB receiver to the end.
4
Auto-connect
1
Ensure that your notebook is switched on and active.
2
Ensure that your Presenter is switched on.
•
If the USB receiver is inserted into your Presenter, release the USB
receiver from your Presenter (Fig. 3).
3
Plug the USB receiver into a USB host on your notebook.
Auto-connection starts.
»
If connection is successful, the LED indicator indicates 1 long
»
blink.
If connection fails, the LED indicator indicates 2 long blinks.
»
The LED blinks upon every successful communication between
»
the Presenter and the USB receiver.
Tip
•
After use, insert the USB receiver into your Presenter for
storage (Fig. 4).
•
Upon the fi rst installation on Mac,
may appear and prompt that the keyboard cannot be
identifi ed. Just click Continue to fi nish the installation, and
then the Presenter will work accordingly.
:
Keyboard Set Assistant
Advertisement
