Check the cord regularly for possible damage. If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard.
Do not allow the cord to come into contact with the soleplate when it is hot. When you have finished ironing, when you clean the appliance, when you fill or empty the water tank and also when you leave the iron even for a short while: set the steam control to position O, put the iron on its heel and remove the mains plug from the wall socket.
ENGLISH Preparing for use Fastening the stand clamp Fold out the clamp on the bottom of the stand and fix the stand clamp to the ironing board or to another stable surface, such as a tabletop. The rubber feet on the bottom prevent the stand from slipping. You can also place the stand on the ironing board without using the clamp.The clamp can then remain folded in.
Page 9
Setting the temperature Put the iron on the iron stand. Set the required ironing temperature by turning the temperature dial to the appropriate position (see section 'Tips' for extra information). Check the laundry care label for the required ironing temperature: Symbol on Type of fabric laundry care label...
ENGLISH Tips - If the fabric consists of various kinds of fibres, always select the temperature required by the most delicate fibre, i.e. the lowest temperature. For example: if an article consists of 60% polyester and 40% cotton, it should be ironed at the temperature indicated for polyester (2) and without steam.
Page 11
Take the iron from the stand. HI575 only: put the iron back on the stand when the temperature light starts blinking.This indicates that the iron has cooled down below the set temperature. When you stop ironing for a while, always put the iron on the stand to allow it to heat up again.
Page 12
ENGLISH Features Spray function You can use the spray function to remove stubborn creases at any temperature. Make sure that there is enough water in the water tank. Press the spray button several times to moisten the article to be ironed. Shot of steam A powerful shot of steam helps remove stubborn creases.
Electronic safety shut-off function (HI575 only) The electronic safety shut-off function automatically switches the iron off if it has not been moved for a while. To indicate that the heating element has been switched off, the auto-off light will start blinking and you will hear an audible signal. - In horizontal position, this will happen after 30 seconds.
ENGLISH Set the steam control to position 0. Open the cap of the filling opening and fill the water tank up to the maximum level.Then close the cap again. Do not pour vinegar or other descaling agents into the water tank. Put the iron on its stand.
Page 15
Storage Make sure the iron has cooled down sufficiently before you put it away. Remove the mains plug from the wall socket and let the iron cool down. Set the steam control to position 0 (no steam). Set the mode switch to position ∫ (cordless). Empty the water tank.
By doing this you will help to preserve the environment. Guarantee & service If you need information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet).