Maintenance; Lubricating The Cutting Unit; Removing And Installing A Cutting Unit - Toro LT-F3000 Installation Instructions Manual

Maintenance

Lubricating the Cutting Unit

Service Interval: Before each use or daily
Grease Type: No. 2 lithium grease
1. – Grease every 50 hours
Removing and Installing a
Cutting Unit
Removing a Cutting Unit from the
Machine
1. Position the machine on a level surface. Shut off
the engine, set the parking brake, and remove
the key from the ignition switch.
2. Unlatch and lower the cutting unit to the ground.
3. Remove the 2 bolts that secure the cutting unit
motor to the drive end. Remove the motor and
secure it out of the way.
4. Remove the cap and remove the nut (M24) and
washer from the pivot shaft
Note:
Retain the washer on the center cutting
unit between the arm and the pivot casting, as
well as the other hardware
Figure 11
(Figure 12).
(Figure 13).
7
Replace any damaged grease fittings.
Important:
Use 1 pump of grease on the
height-of-cut adjusters and 3 pumps of grease on
all other grease fittings.
Refer to Figure 11 for where to grease the cutting
units.
2. – Grease daily
1. Cap
2. Nut
Figure 12
3. Washer
g036809
g037002