Table of Contents
Advertisement
Configuration Options via Command Line
Caution: Do NOT initiate simultaneous menu sessions to run commands. Doing
so will interfere with active processes and may corrupt the system configuration
and/or cause the HCS6300 card to cease normal operation.
Access the HCS6300 Main Menu
Note: The HCS6300 must be connected to an IP network for Telnet access. For direct access
to the HCS6300 Service Port, use the FTDI TTL-USB cable (P/N TTL-232R-5V-AJ). See also
"Network and Communication Setup" on page 16 for further information.
1. Establish communication with the HCS6300 using Telnet or via a direct connection to the
HCS6300 Service Port.
2. Once communication is established, press Enter to refresh the menu display in the terminal.
You now have access to the HCS6300 configuration Main Menu (see example below).
3. At the [Main] Command > prompt, type the desired menu command and press Enter.
Note: You can always press Enter at the [Main] Command > prompt to display the
HCS6300 Main Menu. Main Menu options may vary from the example shown, depending on
the HCS6300 firmware version.
The following sections describe the configuration commands.
Example: HCS6300 Main Menu
------------------------------------------
Main Menu
(Copyright 2012 - LGE USA)
------------------------------------------
info
System Information
rf
Set RF Channels
mrf
Print RF Channels Map
list
List Cards
card
Card Menu
xrst
External Card Reset
setip
Set Up IP Address
pi
Install PI Key On All Cards
pr
Reload PI Key on All Cards
upd
Update Firmware
bits
Read MUX Bitrates
rawbits Read Bitrates at Backplane Connector
crosspt Configure Card Number to Channel Assignment
rstpwd
Reset Password (for Reload PI Key on Web UI)
[Main] Command >
206-4122
31
Advertisement
Table of Contents
