Mounting Discrete I/O Slave Units - Hitachi HIDIC EH-150 Applications Manual
Devicenet master module(eh-rmd)/ slave controller(eh-iocd)/ discrete i/o slave unit (rdx16d,rdy16tp,rdy16r)
Hide thumbs
Also See for HIDIC EH-150:
- Applications manual (114 pages) ,
- Instruction manual (29 pages) ,
- Applications manual (20 pages)
Table of Contents
Advertisement
13.3 Mounting Discrete I/O Slave Units
(1) In case of fixing with screws
Check the dimension of the slave unit to be mounted and make appropriate installation holes on the control
board. Then fix the slave unit using M4 screws. (Fix the slave unit at two places, at the upper right and bottom
left when viewing from the front.)
(2) In case of fixing on the DIN rail
Mount the backside of the slave unit onto the DIN 35 mm rail.
1]
Hook the claw attached to the back of the slave unit onto the DIN rail.
2]
Press the slave unit into the DIN rail until it clicks.
3]
After mounting the module, check to make sure the slave unit is securely fixed.
Slave unit
4]
Secure the slave unit by installing commercially available DIN rail fixing brackets from both sides.
The slave unit may move out of place if not secured with the fixing brackets.
2]
13-2
Chapter 13 Mounting and Wiring
1]
DIN rail
Caution
Advertisement
Table of Contents
