Measurement Of An Oblique Edge (Measurement Type 16) - Siemens SINUMERIK 840D sl Function Manual

Input variable
$AC_MEAS_FRAME_SELECT
$AC_MEAS_TYPE
* optional
The following output variables are written for measurement type 15:
Output variable
$AC_MEAS_FRAME
8.5.3.8

Measurement of an oblique edge (measurement type 16)

Measurement of an oblique edge ($AC_MEAS_TYPE = 16)
This measurement determines the position angle of the workpiece and enters it in the frame.
A setpoint angle in the +/- 90 degrees range can be input. This can be interpreted as the
resultant rotation of the workpiece after the result frame for the active WCS has been
activated.
Figure 8-12 Oblique edge in planes G17, G18 and G19
The values of the following variables are evaluated for measurement type 16:
Input variable
$AC_MEAS_VALID
$AA_MEAS_POINT1[axis]
$AA_MEAS_POINT2[axis]
$AA_MEAS_SETANGLE
$AC_MEAS_ACT_PLANE
$AC_MEAS_FINE_TRANS
$AC_MEAS_FRAME_SELECT
$AC_MEAS_T_NUMBER
$AC_MEAS_D_NUMBER
Extended Functions
Function Manual, 10/2015, 6FC5397-1BP40-5BA3
8.5 Setting zeros, workpiece measuring and tool measuring
Meaning
Calculated as additive frame unless otherwise specified *
15
Meaning
Result frame with translations
Meaning
Validity bits for input variables
Measuring point 1
Measuring point 2
Setpoint angle *
Calculated as active plane unless otherwise specified *
0: Coarse offset, 1: Fine offset *
Calculated as additive frame unless otherwise specified *
Calculated as active T unless otherwise specified (T0) *
Calculated as active D unless otherwise specified (D0) *
M5: Measurement
539