List of related manuals Drive hardware manuals and guides Code (English) ACS355 user’s manual 3AUA0000066143 ACS355 drives with IP66/67 / UL Type 4x enclosure 3AUA0000066066 supplement ACS355 quick installation guide 3AUA0000092940 ACS355 common DC application guide 3AUA0000070130 ACS355 enhanced sequence program (+N830)
Page 3
Supplement ACS355 drives with Ex tc dust explosion protection enclosure for explosive atmospheres (option +B063 +C215) Table of contents 2017 ABB Oy. All Rights Reserved. 3AXD50000042618 Rev A EFFECTIVE: 2017-04-19...
This chapter contains information on the manual, gives safety instructions and other general information for the reader. Applicability This supplement applies to ACS355 drives when used in potentially explosive dust atmospheres in Zone 22. The drive must include: • the option +C215: Dust explosion protection enclosure for explosive atmospheres, ATEX II 3D, Ex tc IIIB T65°C Dc...
You are expected to know the fundamentals of electricity, wiring, electrical components, electrical schematic symbols and ATEX/Ex regulations. Contents This document is a supplement to ACS355 user’s manual (3AUA0000066143 [English]). The chapters of this supplement are briefly described below. • Introduction to the manual (this chapter) introduces this manual.
Exclusion of liability ABB is not responsible for the implementation, verification and validation of the overall system. It is the responsibility of the end user (or other party) who is responsible for the overall system, system safety and compliance with ATEX/Ex regulations.
Checking the delivery The delivery contains: • the ACS355 drive with the ATEX/Ex marking label • a set of warning stickers in 10 languages • this manual (3AXD50000042618 [English]). Make sure that all items are present and that there are no signs of damage. Notify the shipper immediately if damaged components are found.
12 Option description and instructions Markings of the drive This sticker is attached next to the type designation label of the drive to signify the ATEX/Ex classification. Item Description The European Commission mark for Ex products. Equipment group II: Product for surface industry (other than mining applications). Category 3D equipment.
[English]). Note: Make sure that the installation is designed and done according to the applicable local laws and regulations. ABB does not assume any liability whatsoever for any installation which breaches the local laws and/or other regulations. If the recommendations given by ABB are not followed, the drive may experience problems that the warranty does not cover.
The ACS355 drive with the option +B063+C215 complies with the European ATEX product directive 2014/34/EU. The EU declaration of conformity is shown below. ATEX certificate The ATEX certificate for the ACS355 drive with the option +B063+C215 (VTT 023X) is shown below.
Page 15
Option description and instructions 15 Note: If the EU Declaration of Conformity is needed in any other official language of European Union than in English, contact ABB...
Product and service inquiries Address any inquiries about the product to your local ABB representative, quoting the type designation and serial number of the unit in question. A listing of ABB sales, support and service contacts can be found by navigating to www.abb.com/searchchannels.
Page 20
Contact us www.abb.com/drives www.abb.com/drivespartners 3AXD50000042618 Rev A (EN) 2017-04-19...