Siemens SINUMERIK Series Function Manual page 53

75413
Explanation
Response
Remedy
Cancel/clear criterion
75414
Explanation
Response
Remedy
Cancel/clear criterion
75415
Explanation
Response
Remedy
Cancel/clear criterion
SINUMERIK Run MyCC /ROCO
Function Manual, 09/2018, A5E45818879B AA
ROCO channel %1 read-in error for configuration file %2 line %3
When reading in the configuration file, an illegal syntax was identified or the compensation
was still active.
Positive line numbers indicate the incorrect line in the configuration file.
A line number of -1 indicates that the compensation was still active as the configuration file
was to be read in.
A line number of -2 indicates that the configuration file was not found. This must be created
in subdirectory "ROCO_COMP" of the "COM.DIR" folder. The file name complies with the
following schematic:
ROCOn_CH#.DAT
# stands for the channel number - and n is a positive, integer number less than 1000000.
A line number of -3 indicates that the reserved heap memory for reading in the data is not
large enough.
A line number of -4 indicates that the call parameter for CC_ROCOREAD does not lie in the
permissible range extending from 1 up to 9999999.
A line number of -5 indicates that the number of LINK elements differs from the number of
channel axes after keyword COMPCHANAX.
--NOREADY--, --NONCSTART--, --SETVDI--, --SHOWALARM--
Configure the configuration file, deactivate the compensation before reading in the configu‐
ration file or increase the amount of memory reserved for the heap memory.
--RESETCLEAR--
ROCO channel %1 error in the compensation calculation %2
An unpredictable error occurred in the algorithm.
Generates a series archive and send this to the SINUMERIK Hotline.
--SETVDI--, --SHOWALARM--
Have the configuration file corrected
--RESETCLEAR--
ROCO channel %1 illegal activation of the compensation with non-
referenced axes
Before activating compensation using CC_ROCO - or by setting the GUD ROCO_FUNC‐
TION, all of the axes involved must have been referenced.
--NOREADY--, --NONCSTART--, --SETVDI--, --SHOWALARM--
Reference all axes handled by CC_ROCO
--RESETCLEAR--
Alarms
01.00.00
01.00.00
01.00.00
53