Installation - Fujitsu PB-91469G-LS-256BGA User Manual

4 Installation

- Remove carefully the board from the shipping carton.
- Check first if there are any damages.
- Check and compare the jumper setting with the default jumper settings (page 9)
- Open the box CSICE256Y2027FJ01 and take out the four screws. Put the screws with the
slot on top into bottom of the CSICE256Y2027FJ01 > see following figure part "h"
- Note: The connection between CSICE256Y2027FJ01 and the first YQSOCKET256SE
is only once pluggable, since otherwise the pins can break off. Decide how many
YQSOCKET256SE are needed for the required high of the buildup.
- Press/connect carefully
YQSOCKET256SE.
- Remove MCU out of the socket (CS-PACK) before using the probe cable
f: PB-91469G-LS-256BGA
h: CSICE256Y2027FJ01
k: Target board
(e.g. SK-91469G-256BGA)
UG-910022-13
PB-91469G-LS-256BGA V12
Chapter 4 Installation
and smooth the
g: YQSOCKET256SE
i: CSPACK256
- 20 - © Fujitsu Microelectronics Europe GmbH
CSICE256Y2027FJ01 into the