Parking Brake; Key Switch; Throttle Lever; Hour Meter - Toro Groundsmaster 360 31223 Operator's Manual

you, press the foot pedal and release it when the
steering wheel reaches the desired operating position.

Parking Brake

To engage the parking brake, push down on the brake
pedal and press the top forward to latch it
6). To disengage the parking brake, press the brake
pedal until the parking-brake latch retracts.

Key Switch

The ignition switch has 3 positions: O
and S (Figure 7).
TART
1. Power-takeoff (PTO)
switch
2. Oil-pressure-warning light
3. Charge-indicator light

4. Hour meter

5. Differential-lock switch
(2-wheel-drive only)
6. Steering-selector switch
(4-wheel-drive only)

7. Throttle lever

Power-Takeoff (PTO) Switch
The power-takeoff (PTO) switch starts and stops the
attachment (Figure 7).

Fuel Gauge

The fuel gauge (Figure
remaining in the fuel tank.
(Figure
, O /P
FF N
Figure 7
8. Diagnostic light
(4-wheel-drive only)
9. Ignition switch
10. Power point
11. Optional switch location
12. Deck-lift switch
13. Glow-plug light
14. Coolant-temperature-warning
light
8) indicates the amount of fuel
,
REHEAT
1. Fuel gauge
Throttle Lever
The throttle lever
speed. Moving the throttle lever forward toward the
F position increases the engine speed. Moving
AST
it rearward toward the S
engine speed. The throttle controls the speed of the
PTO and, with the traction pedal, controls the ground
speed of the machine. Always run the machine
with the throttle in the F
attachments.
Hour Meter
g014169
The hour meter
hours that the engine has operated. It operates when
the key switch is in the R
for scheduling regular maintenance.
Engine-Coolant-Temperature-Warning
Light
This light glows and the attachment stops if the
temperature of the engine coolant is high
7). If you do not stop the machine and the coolant
temperature rises another 7°C (20° F), the engine
shuts off.
Important:
the temperature warning light is on, push the
PTO knob down, drive the machine to a safe, flat
area, move the throttle lever to the S
allow the traction pedal to move to the N
position, and engage the parking brake. Allow the
engine to idle for several minutes while it cools to
a safe level. Shut off the engine and check the
cooling system; refer to
System (page
15
Figure 8
2. Fuel-tank cap
(Figure 7) controls the engine
position decreases the
LOW
position when operating
AST
(Figure 7) records the number of
position. Use these times
UN
If the attachment shuts down and
Checking the Cooling
46).
g014170
(Figure
position,
LOW
EUTRAL