Canon MX860 Service Manual page 20

has been received.
##783 TX After transmitting EOR-EOM in ECM transmission, re-
transmission of the procedure signal has been attempted the
number of specified times but failed, or T5 time-over (60
sec.) has occurred.
##784 TX After transmitting EOR-EOM in ECM transmission, ERR has
been received.
##785 TX After transmitting EOR-EOP in ECM transmission, no
significant signal has been received, and re-transmission of
the procedure signal has been attempted the number of
specified times but failed.
##787 TX After transmitting EOR-EOP in ECM transmission, DCN has
been received.
##788 TX After transmitting EOR-EOP in ECM transmission, re-
transmission of the procedure signal has been attempted the
number of specified times but failed, or T5 time-over (60
sec.) has occurred.
##789 TX After transmitting EOR-EOP in ECM transmission, ERR has
been received.
##790 RX After receiving EOR-EOP in ECM reception, ERR has been
transmitted.
##791 TX / During the ECM mode procedure, a signal other than a
RX significant one has been received.
##792 RX In ECM reception, PPS-NULL between partial pages has not
been detected.
##793 RX During high-speed signal reception in ECM, no effective
frame has been detected, and a time-over has occurred.
17 / 64
receiving machine.
- Increase the period of time of the T5
time-over.
- Try a higher transmission level.
- Try a higher transmission level.
- Increase the transmission level of the
receiving machine.
- Try a higher transmission level.
- Increase the period of time of the T5
time-over.
- Try a higher transmission level.
- Increase the transmission level of the
sending machine.
- Increase the transmission level of the
sending machine.
- Try a higher transmission level.
- Increase the transmission level of the
sending machine.