Operating instructions
RDH100RF/SET consists of a RDH100RF wireless temperature controller and a RCR100/433 receiver. The
RDH100RF allows you to set the desired room temperature (setpoint) for the desired time. The unit features an
ergonomic setting knob for easy temperature control.
Display
Actual room temperature in ºC
The unit controls to the selected
comfort temperature
Indicates when there is demand for
heat
Replace batteries
Appears on the screen when the
RF TEST
transmitter is being tested.
Battery compartment
Two alkaline batteries type AA, 1.5 V
Commissioning before start-up
Commissioning
·
Remove the black transit tabs from the alkaline batteries.
·
Check to see if the battery compartment is in the correct position.
·
If no batteries are inserted, fit 2 alkaline batteries type AA in the battery compartment.
A6V101035988_en--_c
RDH100RF/SET
2018-03-30
Subject to alteration
Setting knob
Warmer/colder knob for
selecting the temperature
setpoint
Changing the batteries
1.
Get two new batteries of type AA alkaline, 1.5 volts.
2.
Within one minute: pull out the battery compartment and remove the
batteries, then insert new batteries and replace the battery compartment.
The original set values must be checked after changing batteries!
3.
Make certain the old batteries are disposed of properly, in
compliance with environmental requirements.
Energy saving tips without sacrificing comfort
Never allow room temperatures to exceed 21 C.
Air out rooms: Air out rooms for short periods with open windows and
doors.
Initial power-up
Once batteries are inserted, all symbols are
displayed as shown for about two seconds.
Selecting the required temperature
· Turn the setting knob counter clockwise to
decrease the setpoint, or clockwise to
increase the setpoint in increments of 0.5 °C
· The required temperature is displayed next to
the comfort temperature symbol
Siemens Building Technologies / HVAC Products
DE
EN
FR
IT
NL
ES
PT
CS
HU
PL
SV
FI
ZH
TR
EL
RO
DA