Table of Contents
Advertisement
WARNING
Do not attempt to modify this product or create accessories or
attachments not recommended for use with this product. Any
hazardous condition leading to possible serious personal injury.
OPERATION
WARNING
Do not direct the light beam at persons or animals and do not
stare into the light beam yourself (not even from a distance).
Staring into the light beam may result in serious injury or vision
loss.
WARNING
Do not allow familiarity with tools to make you careless.
WARNING
Do not use any attachments or accessories not recommended
by the manufacturer of this tool. The use of attachments or
accessories not recommended can result in serious personal
injury.
APPLICATIONS
You may use this tool for the purpose listed below:
General illumination of most work area spaces
This product is designed to be powered by either a 18V battery pack
(DC mode) or by electric power (AC mode). Either power source
can be used by installing an approved battery pack or power cord
into the product as described in this manual.
INSTALLING/REMOVING BATTERY PACK
See Figure 1.
Rotate the adjustable head forward as needed to gain access to
the battery port.
Insert the battery pack into the product as shown.
Make sure the latches on each side of the battery pack snap
into place and the battery pack is secured before beginning
operation.
Depress the latches to remove the battery pack.
WARNING
Always remove battery pack or unplug extension cord from your
product when you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery pack or
unplugging extension cord will prevent accidental starting that
could cause serious personal injury.
INSTALLING/REMOVING POWER CORD
See Figure 2.
6
Do not route cord under carpets, rugs, runners, furniture, or
prevent a tripping hazard.
Insert the female end of the power cord into the product as
shown.
Connect the male end of the power cord to the power source.
Make sure the power cord is seated securely before beginning
operation.
To remove the power cord, disconnect the cord from the power
source and then from the rear of the light.
OPERATING THE PANEL LIGHT
See Figures 3 - 4.
product should always be in the OFF status, with the battery
pack removed and power cord disconnected, when not in use.
Do not leave light on while unattended. Failure to follow these
instructions could result in serious personal injury.
Install battery pack or connect product to an AC power supply.
intensity. Rotating counterclockwise will give less light; rotating
clockwise will give more light.
Place the light's adjustable panels in the positions needed to
direct light as desired.
heat to melt some fabrics. To avoid serious personal injury,
never allow the panel light lens to come in contact with anything.
ADJUSTABLE HEAD
See Figure 5.
or hands.
In addition to adjusting the individual LED panels of the light, the
adjustable head can also be set in a variety of positions. To adjust
positions:
Loosen the head adjustment knob.
Adjust head to desired position.
Tighten knob to secure.
MOUNTING/HANGING THE PANEL LIGHT
See Figures 6 - 9.
light offers a variety of hanging and mounting options in both the
needs.
6
WARNING
WARNING
WARNING
CAUTION
Advertisement
Table of Contents
