Philips 23PF8946/37 Quick Use And Hookup Manual

Thank you for purchasing this Philips LCD Television set. You are now the proud owner of a LCD TV set which
promises full value to you as a customer. Before you proceed to install the LCD TV, please follow the steps and
diagrams as shown to familiarise yourself with the correct and safe way of assembling the stand to the TV.
A
SSEMBLING THE
1
3
Bottom of swivel base
(20"/23" models only)
1
2
For swivelling of the stand to function properly, adjust the swivel base at
the back of the stand until arrow is aligned in the center. Align the stand
studs into the holes at the bottom of the set. Put in the screws (provided)
into the 2 holes and tightened with a screwdriver.
CAUTION : While putting in the screws, hold onto the stand.
I LCD TV
NSTALLING
If you intend to install the LCD TV on the wall. ensure you have the following :
– Standard VESA 100 bracket for 15"/17"/20"/23" LCD TV (not supplied) and four spacers found in the accessory bag.
Do the following when installing the LCD TV on the wall :
1
If your VESA bracket does not fit into the slot at
the rear of the LCD TV, proceed to make use of
the four spacers provided. Note : If VESA bracket
fits into the slot, you need not use the spacers.
S
TAND
!
Ensure you have the following before
you assemble the stand :
– Two screws (supplied with set)
– One Screwdriver (not supplied)
Place the set facing down on a protective
sheet close to the edge of a flat surface.
NOTE : No swivel
base for 15"/17" models
Align arrow
to the center
W
ON THE ALL
2
VESA
Bracket
does not
fit
Screw the four spacers to the holes at the rear of
the set. Ensure the spacers are properly tightened
(torque of 1.2N-m or 1 lbf-in).
2
23"/58cm
20"/51cm
For the 20"/23" models, open back
plate cover by gently pulling upwards.
4
23"/58cm
20"/51cm
For the 20"/23"models,
close back plate cover
by gently pushing
downwards.
Spacer
x 4
3139 125 32112
LCD TV
LCD TV
17"/44cm 15"/39cm
For the 15"/17" models, open back
plate cover by sliding the plate cover
downwards and then pull upwards.
17"/44cm
15"/39cm
For the 15"/17" models, Check the stand arm
close back plate cover by is rigid and properly
sliding plate upward. installed. Place the
set upright.
3
Place the VESA bracket on the spacers and
tightened with the VESA bracket screws.
Tighten
VESA
bracket
to spacers