Table of Contents
Advertisement
4. Handling
4.1 Setting the GPS Receiver Unit
The GPS receiver unit is set in accordance with the requirements of the system by using the DIP
switches located on the front panel of the unit.
To prevent erroneous operations, the DIP switches are protected with a cover. As shown in
Figure 4.1.1, when the cover is rotated after loosening the cover screw with a screwdriver, the
switches are exposed thus making it possible to handle them. Switches are handled with a
sharp-pointed object such as a screwdriver and set to "ON" or "OFF" by pushing them up or
down respectively. After accessing the switches, tighten the cover screw to its original state.
Four switches are numbered 1 to 4 from left to right. (The numbers are indicated on their
respective switches.)
Table 4.1 shows the function and setting of each switch. (All the switches are set to "OFF" for
default setting.)
DSW
１２３４
Figure 4.1.1
Switch Operation Method
8
6 F 2 S 0 7 3 8
Advertisement
Table of Contents
