HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
Command
+CSMS
+CREG
+COPS
+CGSMS
Note:
3.12 +CMEE–Set Terminal Error Reporting Format
3.12.1 Command Syntax
Command
+CMEE[=<n>]
+CMEE?
+CMEE=?
3.12.2 Description
This command is used to set whether to use result code: +CME ERROR: <err>
indicates the error related to MS. When you set to use result code, the MS-related
error will generate a result code: +CME ERROR: <err>, which will replace the ordinary
ERROR result code. If the error reasons are not related to MS, the ordinary ERROR
will still be returned.
3.12.3 Defined Values
<n>:
0: Do not use +CME ERROR : <err>result code, only ERROR is returned in case of
error occurrence.
1: Use +CME ERROR : <err>result code, <err> adopts the error code value.
2: Use +CME ERROR : <err>result code, <err> adopts the detailed string value of the
error (default value).
<err>: the value is given in the CME ERROR list in the Appendix 17.2 .
Issue 04 (2013-01-28)
The parameters of +COPS will be displayed depending on registration status of UE.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Parameter
<service>
<n>
<mode>,<format>,<oper>,<rat>
<service>
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>+CMEE: <n><CR><LF>
<CR><LF>OK<CR><LF>
<CR><LF>+CMEE: (list of supported <n>s)<CR><LF>
<CR><LF>OK<CR><LF>
Configuration Commands
35