Page 1
– SUMMARY – This service manual covers only the different points from the service manual, file no. 810-9807, for model SD-9000 since SD-9100 are basically the same designing as SD-9000. Please refer to the file no. 810-9807 for other information.
LASER BEAM CAUTION LABEL WAVE LENGTH:650nm, MAX.LASER POWER:0.45mW When the power supply is being turned on, you may not remove this laser cautions label. If it removes, radiation of a laser may be recceived. PREPARATION OF SERVICING Pickup Head consists of a laser diode that is very susceptible to external static electricity. Although it operates properly after replacement, if it was subject to electrostatic discharge during replacement, its life might be shortened.
1. OPERATING INSTRUCTIONS ... 1-1 General descriptions such as location of mechanical parts and troubleshooting are the same as SD-9000. Please refer to the service manual for SD-9000 (File No. 810-9807). PART REPLACEMENT AND ADJUSTMENT PROCEDURES Part replacement and adjustment procedures are the same as SD-9000. Please refer to the service manual for SD-9000 (File No.
SERVICING DIAGRAMS 1. CIRCUIT SYMBOLS AND SUPPLEMENTARY EXPLANATION 1-1. Precautions for Part Replacement • In the schematic diagram, parts marked F801) are critical part to meet the safety regulations, so always use the parts bearing specified part codes (SN) when replacing them. 1-2.
IC615 may be requested for servicing. Computer (MS-DOS/PC-DOS) Note: • The firmware and setup data floppy discs are not available as service parts. For more information, consult TOSHIBA service office in your area. None ... H ... mH None ...
4. CIRCUIT DIAGRAMS 4-1. Output Circuit Diagram Digital audio signal Waveform points (CNY01) Wave 8 (a) 8 (b) 2, 3, 19 8 (c) 6 (a) 6 (b) 6 (c) Audio data control signal Audio data signal (Front) Front out DAC control signal Surround out Center sub...
4. CIRCUIT DIAGRAMS 4-1. Output Circuit Diagram Digital audio signal Waveform points (CNY01) Wave 8 (a) 8 (b) 2, 3, 19 8 (c) 6 (a) 6 (b) 6 (c) Audio data control signal Audio data signal (Front) DAC control signal Front out...
Page 17
Part Loca- Part Loca- Part Loca- Part Loca- Part tion tion tion tion CNX01 A9 CX06 CX33 CY03 CY30 CNX02 J10 CX07 CX34 CY04 CY31 CNY01 C1 CX08 CX35 CY05 CY32 CNY02 G8 CX09 CX36 CY06 CY36 CNY03 B8 CX10 CX37 CY07 CY37...
Page 18
CNX01 JX01 Composite video output C-16 (a) Pin (b) Pin CVBS output 75 terminated 100% color bar V: 500 mV/div H: 20 s/div CNY01 JX01 S-video output D-16 (a) Pin (b) Pin (c) Pin S-Y/C 75 terminated 100% color bar V: 500 mV/div H: 20 s/div JY01 L ch output / R ch output...
Page 19
ICY17 ICY01 3-STATE ICY07 ICY21 DA CONVERTER AND GATE BUFFER OP AMP ICY08 OR GATE ICY22 ICY18 3-STATE AND GATE BUFFER ICY09 INVERTER ICY19 OR GATE ICY23 AND GATE ICY20 DA CONVERTER ICY02 ICY24 REGURATOR OR GATE ICY10 D-IN ICY11 OSCILLATOR ICY03 OP AMP...
The parts identified by !( ) mark are critical for safety. Replace only with part number specified. The mounting position of replacement is to be identical with originals. The substitute replacement parts which do not have the same safety characteristics as specified in the parts list may create shock, fire or other hazards.
SPECIFICATIONS DVD Video Player/Outputs/Supplied Accessories [DVD Video Player] Power supply Power consumption Mass External dimensions Signal system Laser Frequency range Signal-to-noise ratio Audio dynamic range Harmonic distortion Wow and flutter Operating conditions [Outputs] Video output S video output Color difference output (interlaced) Color difference output (progressive) Audio output (optical) Audio output (coaxial)