LG -600 User Manual page 15

5-3-2
Open label paper roll, make sure it is
inside or outside volume. As shown on the
right label paper roll (outer volume) to
install the paper roll rack
5-3-3
Pull one end of the label, right
diagram from the label below the guide
rod, sensor components, labels limit
bracket through until the front of the print
head and printing rubber roller
5-3-4
Knob roll holder bracket and tag limit
the location of the bracket is adjusted
about the label side can take the middle
position of the paper
5-3-5
According to the currently installed
on the size of the label and type (cutting
or black mark), select the detection
method and appropriate adjustments to
the left and right position of the sensor
through the sensor adjustment knob to
ensure that the sensor can effectively
detect the identification to label。
※ 黄色箭头指示处是透光传感器，向左
10mm 位置，白色箭头指示处是黑标传
感器。
5-3-6 Close the handle of a printhead 。
5-4
Label and ribbon installation considerations
□
Please note that operation Do not use sharp hard objects, such as touching
。
。
channel fixed。
Adjustment knob
黑标、 透光传感器位置
Label sensor(Gap and black mark)
标签限位挡片
Paper fixed position
Label sensor
Label guider