English
BATTERY REMOVAL/INSTALLATION
1.
Battery removal
Hold the housing tightly and push the battery
latches to remove the battery (see Fig. 2).
CAUTION
Never short-circuit the battery.
2.
Battery installation
Insert the battery while observing its polarities
(see Fig. 2).
CHARGING
Before using the driver drill, charge the battery as
follows.
1.
Connect the charger's power cord to the
receptacle.
When connecting the plug of the charger to a
receptacle, the pilot lamp will blink in red (At
1-second intervals).
2.
Insert the battery into the charger
Firmly insert the battery into the charger until the
line is visible, as shown in Fig. 3, 4.
3.
Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light up
continuously in red.
When the battery becomes fully recharged, the
pilot lamp will blink in red (At 1-second intervals).
(See Table 1)
(1)
Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the
charger or the battery.
Battery
Pilot lamp
Line
<BSL1430>
30
Handle
Latch
Push
Pull out
Fig. 2
Battery
Fig. 3
Line
<BSL1830>
After insert
Fig. 4