Table of Contents
Advertisement
b) Press in on the locking arms, and push
the indicator light out of the component
cover.
Locking Arm
c) Splice the indicator light wires to the
wiring harness using two twist-on wire
nuts (see steps 6d and 6e on the pre-
vious page for the procedure).
8.
To remove the timer:
a) Pull the knob off the timer shaft.
b) Remove the two screws and remove
the timer from the component cover.
Timer Knob
All manuals and user guides at all-guides.com
Indicator
Light
Timer Screws
c) Disconnect the three wires from the
timer terminals. The wires are con-
nected as follows:
Terminal 1 = cutoff switch wire
Terminal 2 = timer motor wire
Terminal 3 = AC (Black) wire
Cut Motor Wire Here
d) Cut the timer motor wire going to the
crimp-on connector at the indicated lo-
cation shown above.
e) Splice the timer motor wire to the wir-
ing harness using a twist-on wire nut
(see steps 6d and 6e on the previous
page for the procedure).
Continued on the next page.
4-3
Terminals 1
2
3
Timer
Advertisement
Table of Contents
