Advertisement
Inspection
figure a
• The packaging has been designed to protect the wallpack from damage during transit. Inspect
product for damage before installation.
Direct mounting to recessed box Wall Mounting
1. Remove the mounting plate loosening 2 set screws from the fixture. (figure a)
2. Mount luminaire to wall over recessed wiring box using hardware by others (minimum size 8-32
screws) while leveling the product.
3. Complete the wiring to the power source and ground. Push connections into outlet box.
NOTE: Make sure that all electrical connections are in accordance with the National Electrical Code
figure b
(NEC) and any applicable local code requirements.
NOTE: Check the rated input voltage on the luminaire product label, and verify that the supply voltage
meets the product requirements.
Make supply wiring and luminaire wiring connections inside the wiring box:
» CONNECT WHITE (common) SUPPLY WIRE TO WHITE FIXTURE LEAD.
» CONNECT BLACK (hot) SUPPLY WIRE TO BLACK FIXTURE LEAD.
» CONNECT GREEN (ground) SUPPLY WIRE TO GREEN FIXTURE LEAD.
4. Care should be taken when mounting fixture not to pinch the wire leads. Align the fixture against the
mounting plate. (figure b)
5. Secure the fixture by tighten the 2 set screws to lock the mounting plate. (figure a)
6. To weather-proof for outdoor installation, be sure to seal all holes in fixture housing (mounting,
conduit, plugs, photocontrols, etc.) with silicone sealant.
» DO NOT OPEN THE LENS.
» DO NOT TOUCH THE SURFACE OF THE LEDS.
CAUTION: This fixture must be mounted in the LENS DOWN position.
Maintenance
• Depending on environmental conditions, it may be necessary to clean the lens in order to maintain a
high-efficiency lens. (Use solvent-free cleaners.)
Storage
• Prior to installation, the product should be placed in a covered, dry storage. The storage location
should not exceed the normal operating temperature of the product.
Installation Instructions
Advertisement
