Connecting The Unit; Erv Interface Module; Erv Wired Remote Controller - Samsung AN026JSKLKN Series Installation Manual

Connecting the unit

Make sure to disconnect the power cable and power supply before connecting the ERV to other control solutions . If not, it
may cause malfunction due to electrical interference .

ERV interface module

It does not need to connect the ERV interface module in case of individual control . Connect the ERV interface module to the
MaSTER ERV only, in case of centralized control .
ERV interface module
CN3 CN2
RED BLK
ERV
• Check the polarity when connecting Cn4 of the interface module and the V1, V2 of the ERV . (Connection of V1
and V2 must not be switched . )
CAUtIoN

ERV Wired Remote controller

ERV Wired Remote controller
Electric wire
(Field supplied)
ERV PCB
1 . Connect the Cn4 of the ERV interface module to the V1, V2 terminal of
the ERV PCB . (DC 12 V)
2 . Connect the Cn3 of the ERV interface module to the F1, F2 terminal of
the ERV PCB .
1 . Remove the back cover of the ERV wired remote controller .
2 . Connect the COM a (F3), COM B (F4) of the ERV wired remote controller
to the F3, F4 terminal of the ERV PCB .
3 . Reassemble the back cover and the ERV wired remote controller .
ENGLISH-18