Toshiba V Series Operation Manual page 47

3.2 Network Parameter Setting
(16)If the EN7 module information is read out of the serial communication port normally,
confirm that the EN7 module information can be read out through the Ethernet.
To confirm that the information could be read out through the Ethernet, first
disconnect the RS-232C cable.
Make entries on the transmission parameter setting screen for confirmation through
the Ethernet.
Select Ethernet as means of transmission. The other settings need no change
because the settings used in reading the information from the serial communication
3
port are used as they are.
Click [OK].
Start the configuration editor [Hardware configuration] for controller A to open the
screen which shows the registered hardware configuration for controller A. Then
select EN741 and execute [Edit (E)] [Parameter setting (P)] to open the following
screen.
When [Tool and Ether card (B)] is clicked, the network information that the Ethernet
module has is displayed through the Ethernet.
33
6F8C0878