Intended Use - DeWalt XR FLEXVOLT DCB500-QS Original Instructions Manual

Intended Use

This corded power supply is designed for professional use in D
tools.
DO nOT use or store under wet conditions or in the presence of flammable liquids or gases.
DO nOT let children come into contact with the tool. Supervision is required when
inexperienced operators use this tool.
• Young children and the infirm. This appliance is not intended for use by young
children or infirm persons without supervision.
• This product is not intended for use by persons (including children) suffering from
diminished physical, sensory or mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their safety. Children should
never be left alone with this product.
Introduction
The DCB500 D WALT corded power supply is designed to provide power for D
e
2x 54V FLEXVOLT™ cordless tools.
Your D WALT corded power supply should only be used with a power supply
e
corresponding to the voltage on the rating plate of the DCB500, and not with DC
power sources.
The DCB500 corded power supply is suitable for use with double insulated 2x 54V
FLEXVOLT™ cordless tools.
Additional Specific Usage Instructions
The corded power supply may become warm to the touch during use. This is a normal
condition and does not indicate a problem.
iMPORTAnT. The power supply is not user serviceable. There are no user serviceable
parts inside the power supply. Cord replacement may be conducted at an authorized
service centre.
Installing and Removing the Corded Power Supply into and
from Tool (Fig. B–D)
Before inserting the corded power supply into your tool, remove the end of the dust cover
( 4 , Fig. B) from the tool's corded power supply receptacle if applicable. Pull the dust cover
away from the tool's corded power supply receptacle so that it does not interfere with
insertion of the corded power supply. Inspect the tool's corded power supply receptacle for
debris. Debris inside the receptacle can prevent the corded power supply from fully seating.
If debris is present, clean it using low pressure air or vacuum cleaner. Refer to tool manual.
English
WALT 2x 54V FLEXVOLT™
e
WALT
e
7